1 / 5
Kayak Scupper Transducer Mount for a Lowrance TripleShot — zdjęcie 1
1 / 5

Kayak Scupper Transducer Mount for a Lowrance TripleShot

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A four-part kayak transducer mount that clamps through a scupper on one M6 screw.

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
39
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This puts the transducer under the hull without hanging an arm off the side of the kayak. It clamps through a scupper on one long M6 screw, and you tighten the wing nut from inside the boat instead of lying under it.

Four printed parts. The metal Lowrance transom bracket stays in the assembly so the transducer mounts the way it was meant to, the cable runs in its own channel beside the screw, and the front cap comes off with four screws if you need to reach the hardware without taking the clamp apart.

Bring your own M6 screw, nuts, wing nut and M3, M4 and M5 socket screws; the transducer and its bracket are yours too. My scupper is already drilled out to fit, so measure your own before you cut anything. Small fit coupons are in the download so you can test the throat profile for a few grams of filament. The photos are of my own installed mount.

Remix of the Scupper Transducer Mount by digitalpowers, shared back under CC BY-SA.

If you fit one to a different hull, please leave a comment with what you had to change. I would like the next version to fit more boats than mine.