1 / 1
Handbrake button - Toyota 86/Scion FRS/Subaru BRZ — zdjęcie 1

Handbrake button - Toyota 86/Scion FRS/Subaru BRZ

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement button for your handbrake

Ocena
0 / 5
Polubienia
1
Pobrania
3
Wydruki
0
Wyświetlenia
28
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Many years ago, I attempted to paint my handbrake button black. But managed to mangle it in the process of removing it. It's pretty difficult to remove, so I assume others will be in the same boat. 

I’ve modelled a new one that should be a bit easier to install. The thread used is M5x0.8mm, so I used a 0.1mm layer height to try and fully form them. It’s tight but nowhere near as tight as the stock button gets. The thread length is also reduced to make installation and removal easier. 

I also put holes around the diameter to make installation and clocking orientation easier. Simply use a 3mm (~1/8") Allen wrench to fasten it. The holes are hidden when reinstalling the rubber grip. 

Recommended settings

  • 0.1mm layer hight

  • Minimum of 3 walls

  • Infill 60%

  • Manually disable internal support, it’s not needed

  • Setting seams to rear hides them out of view on the bottom of the button

  • I used ASA for temperature and UV resistance

Tagi