Centauri Carbon 2 Vent Kit – Magnetic 4" Exhaust Adapter, Ducting & Wall Vent
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
KODNA.NET | 16-part printable 4-inch exhaust system for the Elegoo Centauri Carbon 2: magnetic adapter, pipes, elbows.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Vent your Centauri Carbon 2 outdoors without drilling into the printer. This modular 4-inch system routes the CC2's exhaust up like a chimney, across the ceiling and out through the wall. Mix rigid printed pipe and standard laundry hose to fit any room.
FEATURES
- Magnetic adapter: 4 × 10x3 mm magnets hold it over the rear exhaust fan. Optional screw holes match the factory screws.
- One joint standard: every pipe, elbow, coupler and hose adapter plugs into every other (101.0 mm male / 101.6 mm socket, 30 mm deep).
- 90° tee branch for a soldering station, with a cap plug to close it when you only print.
- Pest-proof wall vent: flange with through-wall tail plus a hood with 4.95 mm slots.
- Every part fits a 254 x 254 mm plate and is already oriented to print. STL + 3MF included.
PARTS (file names)
- KODNA_EXH_Printer_Adapter – magnetic CC2 mount, 4" outlet
- KODNA_EXH_Straight_240 / Straight_120 – straight pipes
- KODNA_EXH_Coupler_FF / Coupler_MM / Inner Male Couple – join two pipe ends / two sockets
- KODNA_EXH_Elbow_45 / Elbow_90 – turns (two 45s make a 90)
- KODNA_EXH_Tee_90 – soldering-fume branch
- KODNA_EXH_Reducer_4to2p5 – branch to 2.5" hose (63 mm end)
- KODNA_EXH_Cap_Plug – closes the branch
- KODNA_EXH_Flex_F / Flex_M – laundry hose adapters
- KODNA_EXH_WallVent_Flange / WallVent_Hood – exterior wall vent
- KODNA_EXH_Bracket_Horseshoe – U-strap for wall or ceiling
HARDWARE
- 4 × N52 disc magnets, 10 x 3 mm
- 4" laundry/dryer hose + 4" hose clamps
- Foil HVAC tape for the joints
- #8 or 4 mm screws (brackets and wall vent)
- Optional: 4" inline duct fan. The CC2's own fan is sized only for the printer, so add one for long runs or the soldering branch.
ASSEMBLY TIPS
- Point male ends downstream (toward the outside).
- Seal every joint with foil tape.
- Trim the wall vent tail to your wall thickness. Caulk behind the flange; one set of screws holds both flange and hood.
- Keep the outside vent away from windows, doors and air intakes.
Not affiliated with or endorsed by ELEGOO.