Tea-Light Jack-o'-Lanterns: 6 Faces, Support-Free
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Six hollow carved pumpkins that glow over a standard LED tea light. No supports needed.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 196
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Autumn & Halloween
- Licencja
- Creative Commons — Attribution — Noncommercial
Light up your Halloween with a whole patch of jack-o'-lanterns! This set has six carved pumpkins, each with its own personality:
Classic: triangle eyes and a toothy grin
Sinister: angry eyes and a jagged sawtooth smile
Cute: happy closed eyes, blushing cheeks and a big open smile
Spooked: wide eyes and a shocked "O" mouth
Vampire: narrowed eyes, arched brows and fangs
Cat: slit-pupil eyes, a little nose and whiskers
Each pumpkin is hollow with an open bottom. Set it over a standard 38 mm LED tea light and the face glows. Every pumpkin also has its own twisted stem.
Designed to print without supports
Each face was designed so that no part of the wall hangs down into a hole. Teeth point up from the lower lip or run all the way across the mouth, so nothing has to print in mid-air. The inside of the dome is hidden, so a little roughness there won't show.
Specs
Size: about 100 × 100 × 80–86 mm (height varies with the stem)
Bottom opening: 44 mm, fits standard 38 mm LED tea lights
One piece, no assembly
Recommended print settings
Material: PLA (orange, or a light/translucent orange for a brighter glow)
Layer height: 0.2 mm
Walls: 3–4
Infill: 10–15% (it only affects the solid area under the stem)
Supports: none
Orientation: as provided, flat base on the bed
Scaling
80–120% works well. Below about 80%, the opening gets too small for a tea light.
⚠ Use LED tea lights only. A real candle will soften and deform PLA.
Happy Halloween! 🎃 I'd love to see your makes.