Gingerbread Ornaments - Single Extruder Multicolor

These are 2d multicolor Gingerbread Ornaments. This is a set of three. They are 2.5mm thick in the original design (The thickness will depend on print size), so nice and sturdy, but not too thick to be too much. They all have a 3.5mm hole at the top so you can easily pull a thread through (how big the hole is also depends on the size of the print)

Print Settings:

You can scale them to your desired size, I scaled mine so that they are all around 8 by 8 centimeters.

Mine were printed in PLA, but PETG should work just fine.

I recommend using a brim so that adhesion and warp issues can be prevented, but decide for yourself.

The print time varies depending on size, but they generally shouldn't take long. I printed 3 at a time and they took around 1 hour. 

Multicolor Instructions (Assuming layer height is at 0.2mm):

If you don't have an AMS or another multicolor system, you can print both the brown base and the white icing with a single extruder.

The cookie base is 2mm thick, which is 10 layers. The icing is 0.6mm thick, which is 3 layers. A Pause needs to be added at the beginning of layer 11, then you can change the filament color, and will have a nice multicolor print!

You must use the same type of filament for both base and design, otherwise they will fall apart!

 also recommend using filament that is nice and dry to avoid stringing and inaccuracies.

Have fun printing and feel free to post your makes! Merry Christmas!

Note: The original artwork is not mine. I only created the 3D printable file.