1 / 7
Deltarune SOUL Birdcage – Kris's Caged Heart (Halloween / Cosplay Prop) — zdjęcie 1
1 / 7

Deltarune SOUL Birdcage – Kris's Caged Heart (Halloween / Cosplay Prop)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A hanging birdcage with a pixel-art red SOUL inside, recreating the end of Deltarune Chapter 1. Three parts, no supports

Ocena
0 / 5
Polubienia
8
Pobrania
78
Wydruki
0
Wyświetlenia
253
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

At the end of Deltarune Chapter 1, Kris pulls out their SOUL (the red heart you've been steering all game) and locks it in the birdcage in their bedroom. This prop recreates that moment, and it's a great carry piece for a Kris cosplay.

The cage prints in one piece with an open bottom. The base locks into it with a quarter-twist bayonet, and the pixel heart slides onto a post on the base, so you can swap or repaint the heart anytime. A thin spacer ring sits between the cage and base to take up any play, so the twist-lock stays snug and doesn't work loose while you carry it.

Parts

  • cage.stl: ~198 mm wide × 291 mm tall, including the hanging loop. Print upright with the open ring on the bed.

  • base.stl: 208 mm across. Print flange-side down, post pointing up.

  • heart.stl: 135 × 108 × 20 mm. Print lying flat in red.

  • spacer_ring.stl: 198 mm across, 0.6 mm thick. Print flat; it's only a few layers and prints in minutes.

Printer size
The cage needs about 300 mm of Z height. It was printed on a Prusa CORE One L. For a smaller printer, scale all four parts by the same percentage (about 90% fits a 270 mm build height) and the twist-lock will still fit.

Print settings

  • No supports needed on any part. The dome bars stay steep enough to print cleanly.

  • Use 3 or more perimeters on the cage so the bars print solid.

  • 15% infill is plenty for the base and heart.

  • PLA works great: black for the cage, base, and spacer ring, red for the heart.

Assembly

  1. Press the heart onto the post. It's a snug fit; add a drop of CA glue if it feels loose.

  2. Lay the spacer ring on the base's outer flange, around the raised plug.

  3. Line up the three lugs inside the cage's bottom ring with the three notches in the base.

  4. Push the base up into the cage, compressing the spacer, and twist about 25° until it stops.

  5. Optional: drive a small #4 or M3 self-tapping screw through the hole in the cage ring for a permanent lock.

If the fit is still loose on your printer, print the spacer a layer or two thicker. If it's too tight to twist, go thinner or leave it out.

It's built to be carried or hung by the top loop. The base's weight rests on the angled lugs, so it won't drop out.

Fan-made prop. Deltarune is created by Toby Fox; this design is not affiliated with or endorsed by him.

Tagi