Coolant and washer bottle mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount I built to hold two 800ml bottles side by side and mount a small windshield washer pump. I'm using…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
This is a mount I built to hold two 800ml bottles side by side and mount a small windshield washer pump. I'm using 1/4" foam on the bottom and sides and two long zip ties to hold them in place. Printed with support and it was a bit finicky to get the support out of the holes meant for the zip ties. It might print without supports. I printed mine in PETG on an Alphawise U20 put will fit on an Ender 3 sized printer. With .32 layer height, .5 line width and 20% infill, sliced in Cura it took about 12 hours to print.
Please watch the video for more information as far as what bottles I used, what pump, etc, etc.
Category: Automotive