Anti-Flop Lock for Snap MOLLE Pouches
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fixes pouch flop and lift on single-pass / short-strap MOLLE pouches where the strap is too short to secure the bottom.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Attempts to fix pouch flop and lift on single-pass / short-strap MOLLE pouches. Standard NATICK snap straps often leave slack at the bottom, causing the pouch to pull forward when opening Velcro. This clip locks the snap into the lower PALS row to keep the pouch completely rigid.
I made this for my single Velcro grenade pouch, as it wasn't connected at the bottom and only had one strap, so when you pulled it up it would angle up towards me.
This should work on any single MOLLE pouch that has a button snap smaller than 16mm (if yours is bigger, you can edit the STEP.)
I'm not 100% sure how well this will hold up as just a 3D printed item, I printed one from PLA initially and even without a game-days of use it has bowed out slightly. If you find this does work for you but it doesn't survive either give it a go with something tougher (ABS, ASA, PETG) or I had one cut out of stainless steel by JLCs sheet metal system and powder coated for less than £5.
Installation
And just in case - you put it as shown in the image, over the button but through the MOLLE each side, then do the button up, mine was just open to illustrate where it's placed.