Alfawise U20 Tool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick and dirty tool holder for the Alfawise U20. I got the idea for the design from the CR-10 tool holder, hence…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 181
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
A quick and dirty tool holder for the Alfawise U20. I got the idea for the design from the CR-10 tool holder, hence the remix label, but it's designed from the ground up for the U20. It holds all the included tools including the nozzle cleaner (tiny hole in the right rear corner) it also has an extra slot for a small needle nose pliers, two extra holes for whatever you want to use them for and three slots for micro SD cards. The small clip in the front center hooks over the edge of the sheet metal by the LCD screen so it can't slide off the front.
Print it upside down, no supports. Takes about 2 hours at .2 layer height and 60mm/sec
Enjoy, and remix and remodel however you want!
Check out my youtube channel at https://www.youtube.com/user/3rdpig
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
30
Notes:
Printed on the U20.
How I Designed This
Fusion 360
Category: 3D Printer Accessories