Belt Case for UE Megaboom #1

I did not engineer this to perfection and the latest improved iteration is untested.

Main Part / UE Holder: There was severe wobble before with the front beam during printing. So I maxxed a lot of stuff to really make sure it does not happen again. Watch out though if it still happens, I did not test it. I give this part 98% odds of success to print, and 100% to fit the device properly.

(Optional) Belt clip-on: What caused the most severe issues before was the pipe clips just ripping off when ejecting them. And it is a matter of the slot length in combo with rim clip plus at end ... but fundamentally it is a basic weakness of 3D printing in general that it snaps so easily. Again I did not test the latest iteration, and rate this part 90% in working properly and 100% of printing properly (if rotated the right way ... just saying you have to rotate it).

Perhaps you will find yourself in the situation to want to improve both parts and do another iteration.

TL;DR: Watch out: 1. slim "front beam" might wobble too much to print perfectly. 2. Belt loops very heavy/pricey, might break too easily and perhaps awkward to wear vs. strap/rope like in pics.

Settings:

For the belt part, use about 4-5mm wall thickness! This is desperately needed to get rid of snapping. Unless you have a printing program that understands "walls" to mean 3D walls not 2D layer-by-layer. I am 

No support of course. No build plate adhesion.

 You also should do fine-print (0.14mm) so the arches won't fail.