1 / 2
Ruixin Pro Omnix 2 in 1 stone holder Parking Rest — zdjęcie 1
1 / 2

Ruixin Pro Omnix 2 in 1 stone holder Parking Rest

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An attachment to help park the 2 in 1 stone holder for the Omnix

Ocena
0 / 5
Polubienia
1
Pobrania
14
Wydruki
0
Wyświetlenia
57
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — NoDerivatives

After receiving my Omnix sharpener it became obvious these needed a simple parking rest.

I made mine from PLA with 3 perimeters and 25% infil on a Prusa printer.

I have edited the original print making it 5mm longer (75mm) and the shelf end a little taller and longer. I also increased the set screw hole a little more. Designed for a 5mm set screw. Insert set screw before moving forward. Note that depending on your printer you may need to drill out the hole a little larger for the set screw to start and continue threading. I would use something around 4.3 to 4.4mm drill size. The drill I used was .167 inches.

It comes with a support attachment to make it more sturdy. Use caution when attaching this to the main parking rest if you use super glue as I did. I would advise that you turn it upside down and slide it down enough to fit the support shelf, snug up the set screw and use a small dab of super glue gently press it on and slide towards the shaft until it touches. Again do not over use super glue otherwise it may come in contact with the shaft, I held it in place for a minute or so then removed then loosened the set screw removing the parking rest and added a bit more super glue to totally secure it. 

Since I did not order the 4 in 1 stone set I cannot verify it will work correctly however this is designed for the 2 in 1 stone holder and if the 4 in 1 stones are the same width it should work.

Tagi