Skadis adapter for Prusa / INDX spoolholder puck

Mount your spools to a Skadis board instead of the side of your printer. A disadvantage of mounting the spoolholders on the side is that you have to remove all four of them to remove the side panel. And installing them is difficult. You can skip all that and mount them on the wall instead.

This was specifically designed to work with the new INDX spoolholder pucks and also works with the original Core One+ spoolholder puck. (The new pucks are not flat on the bottom like the old pucks: they have tabs to make them easier to align during installation.) You can mount 4 spools on a single Skadis board (assuming your Skadis board is mounted properly to the wall to support the weight). I don't have a 2kg spool, but I tested and confirmed that it can bear that weight and more.

You will need 4 M3x16mm socket head screws to attach the adapter to the puck.

PETG recommended with:

• 4 or 5 top and bottom layers and perimeters.

• 15% Lines infill.

• Paint supports on all four hook using smart fill, choose for support enforcers only (the holes do not require supports).

• I did not need to use brim but you might prefer to.

Notes: The adapter is square rather than round so that it can be printed with the hooks aligned with the build plate for strength. If printed in any other orientation, the hooks may break at layer lines under load.

Depending on where you mount your spools, you may want to look at these other models to reroute your PTFE tubes. Search for "INDX filament" to find more.