1 / 1
Halloween Welcome Sign - Single Extruder Multicolor — zdjęcie 1

Halloween Welcome Sign - Single Extruder Multicolor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Halloween Sign

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
17
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a Halloween Welcome sign, perfect to add to your door or garden to welcome guests and trick or treaters for Halloween. There is a version with holes to add a string for hanging, and without holes.

The colors can be adjusted to your liking. I used red for my lettering to achieve a bloody look, but you could also switch to green for a more slimy welcome, or perhaps purple for a witchy one.

This model can be printed with a single extruder if you don't have a multicolor system, however, all colors must be the same type of filament, otherwise the model will fall apart. Here are the instructions (these instructions are for a layer height of 0.2mm):

The model is 7.4mm thick in total, which makes 37 layers.

The model is seperated into three parts:

  • A 1mm (5 layers) thick bottom to serve as background for the spiderweb, I printed mine in white, but a glow in the dark filament could also look cool.

  • The base, which I printed in black and is 4mm (20 layers) thick.

  • The 'welcome' lettering, which is 2.4mm (12 layers) thick.

To print with all three colors, you will need two pauses at the beginning of the following layers: layer 6 and layer 26.

Step by Step:

  1. Load the print color for your spiderweb (I recommend white, glow in the dark, or translucent filament). Now start the print and let it print until the first pause, which will occur after layer 5 is finished.

  2. Now, unload your spiderweb color, and load your base color (In my case black), and continue the print. Let it print until the second pause, which will occur after layer 25 is finished.

  3. Finally, unload your base color, and load the color you want for the lettering, then continue the print.

  4. Just a few minutes after restarting the print for the lettering, your Model will be finished!

(PS: I will attach the Bambu Lab sliced file for both versions)

Make sure to upload your makes and leave feedback! Happy printing, and Happy Halloween!

Tagi