Crown Of Thorns Cross - Flat Bottom
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple, wall mountable cross with a crown of thorns around its center.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Public Domain
The original .STL file doesn't have a flat bottom, the intricate thorn design continues below the level of the cross, requiring extra supports. I fixed that "problem" for easier post-processing.
The fourth and fifth pictures compare the backs and fronts of the two crosses, with my remix on the left and the original on the right.
Suggested Print Settings:
Material: PLA
Walls: 2
Layer Height: 0.2 mm
Infill: 15%
Brim: Unnecessary (unless you scale it down)
Supports: On (there is a small overhang at the bottom of the thorns)
Only ⁓1.5 hour print at 15% infill!
Multicolor:
Insert pause between the last layer of the cross and the rest of the thorns. Between layer 40 and 41 at 0.2 mm layer height.
Post-Processing:
Remove supports at base of thorns.
Some stringing may occur at the top of the thorns. Just file it off.
Has a nail hole for mounting or you can use a command strip.