Video Laryngoscope for Airway Training (Macintosh and Hyperangulated)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
WiFi video laryngoscope for teaching on manikins, built from a cheap WiFi endoscope camera. Not a medical device.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 92
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A wireless video laryngoscope for airway management training, so that a whole group can watch the intubation on a phone or tablet at the same time. It is built from a cheap WiFi endoscope camera (about 50 EUR) whose complete electronics, battery, LED lighting and WiFi hotspot move into a 3D printed laryngoscope.
IMPORTANT: This is NOT a medical device. It is meant only for teaching on manikins and must never be used on humans. Video transmission via WiFi can lag or drop out.
Full build log with all photos, wiring details and LED resistor calculation: https://blog.josias.de/en/posts/videolaryngoskop/
Versions
Version 1: first draft with a boxy electronics housing, electronics fixed with hot glue.
Version 2: round handle with printed lettering (NOT FOR HUMAN USE on one side, the app name WiFi Look on the other), screwed lid with on/off switch, USB C charging port and status LEDs. Available with a curved Macintosh style blade and with a hyperangulated blade.
Material for version 2
WiFi endoscope camera with 5.5 mm camera head (I used one from OOZAKA), latching switch (12 mm metal push button, normally open), USB C panel socket, one red and one pure green 3 mm LED, resistors 150 Ohm and 33 Ohm, JST SH connectors, 2 screws M2 x 4 mm and 2 nuts M2, thin wire, black hot glue, sandpaper 80 and 220.
Print settings
0.15 mm layer height, 12 wall loops, 30 % infill, with supports, printed lying with the NOT FOR HUMAN USE side facing up. For regular use in teaching I recommend GF ABS instead of PLA, my PLA versions broke at the blade under wrong load. After sanding, a very short pass with a gas burner (well under one second per spot) makes the surface smooth so it slides better in the manikin.
Files
Version2Komplett.3mf is a ready Bambu Studio project with both version 2 laryngoscopes, lids and red lettering. The STL files are single colour. The Fusion 360 projects contain the lettering as a 0.01 mm deep face, so you can extrude it as its own body when you adapt the design.