Removable Magnetic Guard Ring for Cotton Candy Machine (VEVOR 1000 W)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two part magnetic, dishwasher safe guard ring that replaces the screwed sheet metal cover and makes cleaning easy.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Cleaning my VEVOR cotton candy machine (1000 W) was always annoying: sugar falls into the gap between the spinning head and the housing, and the original sheet metal cover is screwed onto rivet nuts, so sugar and sugar water collect underneath it. This guard ring replaces the cover. It is held by magnets, comes off without tools and can go into the dishwasher together with the rest.
Full build log with all photos: https://blog.josias.de/en/posts/zuckerwatteguardring/
Design
Designed in Fusion 360. Two identical halves form a flat ring with 188 mm outer diameter, 100 mm inner diameter and 18 mm height. The top is shaped as a rounded channel without edges where sugar could stick, and a small lip at the inner edge covers the gap to the spinning head. The halves overlap with a step at the joints, so there is no straight gap there either. Because both halves are identical, you only need one file and print it twice.
Hardware
30 magnets 2 x 2 mm (15 per half: 11 hold the half on the machine housing, 4 in the end faces hold the two halves together), glue, a drill to remove the rivet nuts.
Conversion
Unscrew the original cover. Drill out the rivet nuts so the surface is flat, the remaining holes are covered by the ring later. Glue in the magnets and check the polarity first, especially for the magnets in the end faces. Cover the magnets completely with glue so they don't rust in the dishwasher. Then simply place both halves around the spinning head, the magnets pull them into position.
Print settings
Printed in ASA (heat resistant and dishwasher safe) with standard slicer settings and no supports. The ring does not touch the cotton candy itself, it only sits on the housing below the spinning head.
Fits my VEVOR 1000 W machine. Many other cotton candy machines are built very similarly, but measure the inner and outer diameter of your machine before printing. The Fusion 360 project is included in case you want to adapt the ring.