Arched Sword & Knife Display Stand – Push-Fit, Nearly Support-Free
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Arched display stand for cosplay swords and knives – 3 push-fit parts, arch printed on its side, feet flat.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution
A display stand in a classic arched design for cosplay swords, knives and other blade props. The blade stands edge-down in two forks.
The stand consists of 3 parts: the arch and two feet that push onto the fork heads from below. This way every part prints in its best orientation:
Arch: lying on its side → only minimal support inside the wedge slot
Feet: lying flat → no support (both feet are included in one STL, already laid out flat)
The joint engages 15 mm deep and locks in both directions. If it’s too tight, sand it lightly or scale it little bit down; if it’s too loose, add a drop of super glue.
The slot is wedge-shaped and follows the blade’s cross-section, so the blade stands straight:
At the edge: 3 mm
2 mm above: 6 mm
20 mm above: 17 mm
(Includes 0.5 mm clearance per side – designed for a fabric-wrapped blade measuring 2 / 5 / 16 mm.)
Thinner blades will fit as well, they just sit a bit deeper. For thicker blades the slot needs to be widened.
Assembled dimensions: 216 × 110 × 85 mm, 200 mm between the forks. All three parts fit together on a single 250 × 250 mm print bed.
Supports: only for the wedge slot on the arch (e.g. support painting)