Janus - Improved Sealing for Inbxx-L
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A collection of parts to improve the sealing of an Inbxx-L
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 14
- Wydruki
- 1
- Wyświetlenia
- 152
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a collection of parts designed to improve the seal of an Inbxx-L with the goal of providing better humidity control for filament storage.
The first part is to improve the sealing of the front door. To be written. Uses m3 heat set inserts and 12x3mm magnets.
The second part is to improve the sealing of the maintenance hatches on the rear. This part is designed to use standard M3 heat set inserts for each of the holes. Then place two rows of the same adhesive strips along the interior cutout of the part. Prepare the Inbxx by removing the lower bolts/nuts for the hinge. Bolt the part to the rear panel using the holes on each side and then the bottom holes by passing an m3 bolt through the holes on the hinge into the inserts. Note: If you use a semi-smart or semi-smart advance mounted to the rear panel then you will need to not put inserts on the holes and pass the bolt through the part into the mounting plate for the semi-smart. You will need spacers to raise the other side of the semi-smart-this will be provided at some point.