1 / 3
Holly Leaf Clay Cutter Set, Vein Stamp & Holly Sprig Set for Pottery (shrinkage-sized) — zdjęcie 1
1 / 3

Holly Leaf Clay Cutter Set, Vein Stamp & Holly Sprig Set for Pottery (shrinkage-sized)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Clay cutters and a vein stamp for making holly leaves and berry sprigs in pottery, sized so a 68 mm cut leaf fires down

Ocena
0 / 5
Polubienia
8
Pobrania
27
Wydruki
0
Wyświetlenia
113
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Sculptures
Licencja
Creative Commons — Attribution — Noncommercial

A set of 3D-printed pottery tools for making holly decorations in clay: ornaments, tiles, Christmas tree decorations, Christmas tags, and hanging sprigs.

What's included:

  • Holly leaf cutter: cuts a classic spiky holly leaf, 68 mm long.

  • Holly leaf vein stamp: press it into the cut leaf to add the central vein and side veins.

  • Holly sprig set: three leaf cutters (A, B and C) in different shapes, a berry cluster cutter, and 5 mm hole punches positioned so there's at least 5-6 mm of clay between the hole and the edge (so hanging holes don't crack out).

  • Berry plunger: sits inside the berry cutter with 0.5 mm clearance. Hold it down on the clay while you lift the cutter, so the berries stay put instead of sticking inside.

  • Hole pusher: a small tool (16 mm grip, 4.2 mm pin) that pushes clay plugs out of the 5 mm hole punches.

My clay shrinks roughly 11-12% from wet to fired. These cutters are scaled for that, so the 68 mm leaf comes out of the kiln at about 60 mm. If your clay body shrinks more or less, scale the model in your slicer to suit.

How to use

  1. Roll clay to an even slab, about 4-6 mm thick.

  2. Lay the vein stamp on it, veins down.

  3. Place the corresponding cutter over the stamp so the stamp sits inside the outline, then press down to cut.

  4. Hold the stamp in place and lift the cutter straight off.

  5. Press the stamp firmly to imprint the veins, then lift it away. (Or press first at step 2, then cut)

  6. If clay gets stuck in a hole punch, push it out with the hole pusher (You can also use it to push the clay hole from the back if it is still attached to holy).

  7. Smooth the edges with a damp sponge or finger, dry slowly, then bisque, glaze and fire as normal.

Print notes

  • I printed and tested on my Elegoo Centauri Carbon, 0.4 mm nozzle.

  • I used PETG (Elegoo Rapid PETG), 0.2 mm layers.

  • I printed the cutters wide rim on the bed, cutting edge pointing up, no supports needed.

  • Print the berry plunger and hole pusher flat side down, also with no supports.

  • The included .3mf files are ready-to-slice plates with the parts already laid out.

I will add photos when I fire the oputput as well.

Tagi