windscreen washer fluid filter for Dacia Sandero 3, Logan 3, Jogger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
FIlter that fits in the washer opening of Sandero III, Logan III and Jogger, maybe other models, too.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 93
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
There were no filters available for my Jogger and Sandero and there is a high risk of leaves and debris collecting in the area where the lid of the reservoir is.
To prevent anything from falling into the washer fluid tank, i took a closer look at it's opening. On first sight, there was no way to secure a filter, then i realised, the opening is getting narrower on the inside.
So i designed this filter in Tinkercad. Tested it on 3 cars (2 Sandero, 1 Jogger) in my family and it fit everywhere.
It has two holes for a some ribbon or stainless steel rod which make it easier to remove.
Before installing it the first time, i would recommend to secure the part with a short length of rope to protect it from falling into the reservoir. As this design can also be fully inserted into the tank when rotated 90° it might be a good idea to permanently secure the filter with a thin nylon fishing line or something similar.
Better be safe than sorry, i do not know if all the reservoirs are made the same.
Use at least PETG or something more heat resistant than PLA to withstand the higher temperatures in summer.
Model should print without supports as the overhangs are not that steep or wide.