Wall Drawing Robot Pen Holder (Gondola) + Side Weights
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pen gondola and counterweights for use with vertical plotters, polargraphs, or wall drawing robots.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This gondola can be printed in PLA using 0.2 layer height and doesn't need supports. It requires the following hardware to be fully built:
1x M4 screw 40mm: used to hold pen in place
2x M4 nut: to insert in main shaft and pen holding ring to stabilize screw holding pen
2x M8 bolt 40mm: use in main body, holds washers
2x corresponding M8 nut: secure washers to bolt
80x M8 washers (8.4 mm inner × 24 mm outer × 2 mm thick; they usually come in boxes of 100): the main weight on the body and in the counterweights
For the full build you’ll also need GT2 timing belt and a Miuzei 9G micro servo. The servo is held by friction, with no screws. If it feels loose, add a bit of tape to its sides; the extra thickness and grip will make it sit snug in the gap.
Using penny washers instead: If you’d rather use 25 mm penny washers, I’ve included a slightly larger counterweight model in a separate folder. You may need a few more washers. Note that the full build plate download includes the standard M8 washer counterweight (24 mm).
A tutorial for building the entire vertical wall drawing robot is coming soon.