WAS-110 Front Mount 40mm Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fan mount for WAS-110 XGS-PON but mounted to the front instead of the top like other models.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Slides onto a WAS-110 and allows mounting a 40mm fan with clearance for other SFP modules and equipment. All the other models I found online mounted on top of the WAS-110 and I needed more clearance. This might work with other SFP modules, I only tested with the WAS-110.
Tested in a Startech RK1833BKM rack and the door closes without any issues, plenty of clearance, no rattle, etc.
You will need four m3 screws that are the depth of your fan + 10mm. My fan is 20mm so I used 30mm screws (20+10=30).
My exact parts
4x m3 30mm
Random old USB Power brick (only needs 5.5v for the fan, no resistors or anything)
Random old USB cable (cut the end off and solder to the plug adapter included with the fan)
I printed in PETG and have had no issues with brittleness, drooping, etc. Slow down your printer to keep the lines smooth otherwise they will look ugly. I used a simple M220 S50 command at layer 125. Orient like the picture with supports enabled.