Charger Cover for Xiaomi Electric Scooter 5
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Charger Cover Replacement for this electric scooter. Designed to print in TPU
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
Made this on request of a friend who lost the rubber charging cover seal of his "xiaomi electric scooter 5"
Since I had no reference to work with whatsoever, I designed this model from scratch using only the charging port for measurements and test-fitting. It is meant to be placed over the charging port with the handles above the port itself. Although this fits tightly on the port, the handles are meant to attach the cover to the frame using velcro or similar.
I used TPU with a Shore 94A hardness, although I would suggest a slightly harder material. I used 15% infill and 60% infill in the areas of the handles. This fits tightly and should provide some water protection.
DISCLAIMER: I don't claim this to be water-proof! I have NO experience with this 3D-print whatsoever. I might update the model if my friend asks for changes.
Printing the handles might need supports. But just the handles. Everything else prints fine (laying down) w/o them.
If you want to use another material than TPU, you might need to scale the model up a bit. Or send a DM, i might change the model a bit. Be aware that I don't have access to the scooter anymore and cannot test model changes myself.