Spike Pounding / Driving Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cap to slide on 12mm spike for driving into the ground
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Pretty straight forward cap used to step on, push, or hammer a spike into the ground. This cap was designed to fit the HRD spikes used in his products.
The project file is the best route since it has a modifier set up with a high infill density for the portion used to drive the spike, and then lower for print time and efficiency. It also has a seem painting in the inner recess area so it doesn't interfere with the spike fitment.
You shouldn't need some exotic filament, but use something that is heat resistant so it survives transport in cars, etc. 70% infill in lower part, 25% remainder of the part, 3 walls, painted seem on the ID (again, all set in the project file).
Optionally finish with a lanyard for storage. Pictured is 550 paracord.