100mm Land Drain to 110mm Underground Drainage Connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple Print to enable connection of 100mm Land Drain pipe to standard 110mm Foul Sewer / Surface Water pipework
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
This very simple print was a vital connector to allow me to connect standard 100mm 'land drain' flexible perforated pipe into standard 110mm underground sewer pipes (such as Floplast).
The connector pushes into the 110mm adaptor on the sewerage coupling and allows the 100mm land drain pipe to then be Pushed into the adaptor.
In the UK, the official / mass produced / injection moulded parts cost over £30 including delivery, which is ridiculous for such a cheap component.
Printing
Print it 'upside down' with the thick lip on the plate, and you won't need supports. Included is the Prusa Slicer file for a Prusa Core One L printing at 0.2mm without supports and a 20% infill. I printed using PLA, but you may want to use a more hard-wearing filament as it will be underground for a long time!
Fitting
Install into the 110mm connector first, with the help of some silicone spray (the fine ridges on the print catch the rubber gasket, so a lubricant helps), then push the land-drain pipe in the other end until it goes no further. It is simply a slightly tapered insert, and the interference fit is enough to hold the pipe in-place.