X-Carriage for the Prusa Core MK3.5S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Core MK3.5S needed a robust cable management system for the extruder. This is a simple solution that works.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 42
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I like the design of the Prusa i3 MK3 X-axis-cable holder - Roomy Revo Edition and wanted to use it for the Core MK3.5S. Unfortunately, the cable holder is too long and runs into interference at the back of the printer. With a little Microsoft 3d Builder reworking of the STL files, the cable holder is shorter and turns upwards at a 45° angle. No 3mm Nylon support filament is needed for the Core MK3.5S. If using the Revo 6 with the Core MK3.5S, it is suggested to remove the plugs and directly solder the hotend to the wire harness.
I had to use images from 3d builder for the pictures as my printer is full enclosed and it is not possible to take good pictures.