Sensirion SHT4x Smart Gadget Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple housing for the Sensirion SHT4x Smart Gadget.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
A simple housing for the Sensirion SHT4x Smart Gadget. It was created using Onshape. Feel free to modify to your hearts content CLICK
Since the PCB only features two holes at the back, the front locates under a ledge. The same trick was used for the top of the case.
The screw holes printed a bit undersized on my printer. I used a 2.2 mm drill bit for the case bottom (M2 clearance) and a 1.8 mm drill bit for the case top (tapped by the screws). If you do not have such bits handy, you might want to adjust the hole sizes of the model slightly.
The design intends print orientation on the large flat surface of each part. That only leaves the counterbores of the screw holes needing support. You might get away without.
Update:
I saw the Sensirion-made model is using a duct to separate the sampled air from the stale air inside the housing. So I added a duct.