Bird beak mask able to open and close.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modified plague doctor mask with separated upper and lower part, width at jaw is around 11cm, please modify to fit u.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Masks
- Licencja
- Creative Commons — Public Domain
Before printing. (I modified it in Tinkercad)
1. Check to see if it's wide enough, you should be able to widen it without damaging the build but make sure to widen both the lower and upper part and if you need it; the extra part the same amount.
2. The opening of the jaw is a bit sluggish and the jaw can glide slightly to the left and right, but it didn't bother me.
3. Do to the rubber bands wanting to close it, the force needed for the jaw to open the whole mask tends to want to follow your jaw down instead of opening it so making sure you have a way to keep it stuck in place like I did with a construction helmets suspension system is a good idea. And I had to print out an extra part to glue on top of it to be able to drill and fasten the system to the mask.
4. I recommend having some padding to glue to the inside of the mask.
This was my first attempt so make observe my work before printing, I don't want you to waste plastic for a thing that doesn't work like you expect it to.