1 / 1
Motor Switch Enclosure (KOA5L style) for KJD17 / KB-01 Switch — zdjęcie 1

Motor Switch Enclosure (KOA5L style) for KJD17 / KB-01 Switch

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The enclosure is made for a 230 V motor or tool switch that needs to sit in a box with a reset breaker

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
7
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

A small 83 x 83 mm enclosure for a 2-pole on/off motor switch (Kedu KJD17 / Klibo KB-01-KT-T), a reset circuit breaker and two M20 cable glands.

Designed for a 3D printer and built from parametric CAD (STEP files included).

Description

The enclosure is made for a 230 V motor or tool switch that needs to sit in a box with a reset breaker and proper strain relief. The switch and breaker

mount in the front panel, the mains cable enters through a gland on the side, and the rear carries a second gland for a load cable. The lid is held with four

M3 screws into heat-set inserts in the corner bosses.

Features

Body 83 x 83 x 75 mm, lid 83 x 83 x 15 mm, wall 2.4 mm

Front panel: KJD17 switch cutout (46 x 22 mm) and Ø12.3 mm hole for the reset breaker

Side: M20 cable gland, Ø20.5 mm

Rear: second M20 cable gland, Ø20.5 mm

Lid with a 1 mm lip that centres it on the body

Four M3 corner bosses with heat-set inserts (Ø4.2 mm bore)

Countersunk screw holes in the lid

Print settings (starting point)Setting ValueMaterial PETG or ASALayer height 0.2 mmWalls 4Infill 20 % gyroidSupports Only for the front panel cutouts if neededOrientation Body open side down, lid flat side on bed

Print a test piece of the front panel first and check the switch fit before printing the body.

Assembly

Press the M3 heat-set inserts into the four corner bosses with a soldering iron.

Mount the switch from the front. Its snap frame sits in the 46 x 22 mm cutout.

Mount the reset breaker in the Ø12.3 mm hole and tighten the nut from inside.

Install both M20 glands in the side and rear openings.

Wire the switch, breaker and cables. See the safety notes below.

Set the lid on the body and fit four M3 x 12 mm countersunk screws from inside the lid.

Safety

This enclosure carries 230 V mains voltage. Wiring must be done by a qualified person, with the mains disconnected while working on it.

Use cable and glands rated for your load and cable diameter.

Keep mains and low-voltage wiring separated inside the box.

Do not operate the enclosure with the lid off.

Check the printed dimensions against your own switch and breaker before using it.

The enclosure is not tested or certified. The protection rating depends on the print quality, sealing and glands used.