SAG tool for motorcycle front suspension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tool for measuring front suspension SAG on motorcycles
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 146
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A tool that makes measuring front suspension sag much easier.
Attach it with the ruler aligned to the bottom of the chrome inner tube. Secure the top section to the upper fork tube. Do not overtighten, as you will need to slide it up or down.
To measure without load, position the calibrator above the fork slider and align align the centerline of the calibrator with a reference point (such as the fork seal); lift the front wheel off the ground and set it back down—you will then have the measurement in millimeters.
To measure sag, move the calibrator to the lower part of the fork slider, align align the centerline of the calibrator with the same reference point used previously, sit on the bike, then get off; you will then have the sag measurement.
Ideally, you should compress the suspension, have someone reposition the calibrator, and then get off the bike, though it is possible to measure alone if necessary.
You can print two calibrators and set them up on the ruler—one for the "before" position and one for the "after"—so you only need to adjust the calibrator's position between the unloaded and loaded measurements.
If necessary—for instance, if your printout isn't tall enough—you can cut off the top of the ruler without any issues.
The measurements are for a Suzuki GSX-S1000GT, but it should fit other models as well.
Printed with PLA, 0.2 mm layer height.
Supports were used for printing the slider, which was printed at a 45-degree angle.
Supports were omitted from the clip channels.