K1SE/K1C anti-rattle seal
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom TPU seal to sit between the printer frame and top lid to eliminate rattling during prints
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed a TPU anti-rattle seal that sits right between the lid and the frame on Creality K1 (possibly K2) printers to stop any annoying vibrations while printing.
I measured everything out and modeled it in Fusion. The file is provided as a full-frame piece, so you have total flexibility: you can print the entire gasket, or just slice it up in your slicer to print corner pieces (which is what I did).
It was tested on the K1 SE / K2 SE enclosure lid, but it should fit the K1C lid as well as most top risers just fine. You will need to use CA to glue it to the frame of the printer.
Versions Included
1mm Base Version: Sleek, low-profile, and minimal.
2mm Base Version: Extra cushion, allows for ~10% infill to give you maximum vibration and noise dampening.
Recommended Slicer Settings
Filament: TPU 95A (or any flexible TPU)
Wall Generator: Arachne (REQUIRED – the walls are thin, so Classic wall generation won't print them properly)
Layer Height: 0.2 mm
Infill:
1mm version: Solid / 100%
2mm version: ~10% (Gyroid or Grid works great for shock absorption)
Print Speed: 30–50 mm/s (adjust based on your TPU setup)
Supports: None needed
Brim: Not required