The Gorilla Dauber
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Gorilla Dauber was purpose build for bell end/well casing pipe.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 7
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Demo & Assembly Video
The Gorilla Dauber was purpose build for bell end/well casing pipe. It can reach all the way into a hub, so you can lay 1000' of pipe with this thing and not get a single drop on your hands. I've used it for PVC glue & primer, ABS glue & duck butter. The 1/4" shaft makes this thing virtually indestructible as far as daubers go. Plus, the adjustable length lets you get every last drop out of your cans.
I've used these things for years and can't live without them.
Required Parts (per dauber):
1x 1/4-20 Square Nut (0.45"W x 0.19"H)
1x 1/4-20 serrated nut
1x 7-1/4" piece 1/4-20 all thread
1x 3" 1/4"ID roller (Really any 3" roller you can find at homedepot)
Printing instructions:
This needs to be printed in Nylon because of the chemical exposure from the glue. A fiber reinforced nylon will help with warping, but a plain nylon works just fine too.
This part will also require a massive brim to hold it down when it starts to warp. Bed damage is likely!
A heated chamber really isn't necessary. Though, I'd recommend a CF plastic to help with warping if that's the case.
Set infill to 100%
Add pause at top of square nut hole so you can insert hardware during printing.
No supports
Set massive brim (24mm)
See attached YouTube video for assembly instructions.
Note: Hot glue will eventually be eaten by the primer, and start spinning. However from my experience they'll easily last 4+ months. It's hard to say for sure though, most meet untimely ends. If you really want the best dauber, use JB weld if you don't mind the extra work