Anthropic Logo Plaque - 252 mm

An Anthropic logo plaque with rounded corners, a chamfered top edge and a raised mark. The intended colors are an ivory plaque and a black mark.

Dimensions

• Plaque: 252 x 192.98 x 4 mm.
• Mark: 200 x 140.98 mm, raised 1.6 mm above the plaque.
• Overall height: 5.6 mm; border around the mark: 26 mm.
• Corner radius: 8 mm; top-edge chamfer: 1 mm.

Loading and printing

Import both STLs together as one object with two parts, preserving their common coordinates. The mark begins at Z=4 mm, directly on the plaque; it is not a standalone part to print separately.

Print with the flat plaque underside on the bed and the mark upward. No supports. Designed around a 0.4 mm nozzle.

• AMS: assign ivory to the plaque and black to the mark. The geometry needs only one color change at the height boundary.
• Without AMS: assign both parts to one filament, then add a color change or pause on the first layer above 4.0 mm.
• One color: use one filament for both parts; the raised mark remains visible.

This is a near-limit P1P print. Center the model on the 256 x 256 mm plate: only 2 mm remain at either side. Keep the front-left exclusion zone clear. Do not add a brim or other plate objects at this size.

Editable source

Keep the SCAD and SVG together. Adjust plaque_width, margin and mark_height as required, then check the plate placement again.

openscad -D 'part="plaque"' -o anthropic_logo_252mm_plaque.stl anthropic_logo_252mm.scad
openscad -D 'part="mark"' -o anthropic_logo_252mm_mark.stl anthropic_logo_252mm.scad

part="preview" is a display view, not a production STL.

Verification

The combined object was successfully sliced on 2026-10-02 with P1P 0.4, 0.20mm Standard and PLA Basic: approximately 2 h 25 min and 131 g. AMS assignment and the color-change setup were not verified. No physical test print is claimed.

Artwork

The logo belongs to Anthropic. The local SVG came from the anthropic.com page header on 2026-10-02. This is an unofficial decorative 3D adaptation.