1 / 7
INDX PTFE tube paths to the backside mounted filament sensors — zdjęcie 1
1 / 7

INDX PTFE tube paths to the backside mounted filament sensors

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

for 4 Tool, 6 Tool, 8Tool configurations

Ocena
5 / 5
Polubienia
5
Pobrania
5
Wydruki
1
Wyświetlenia
177
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Core One + Gen2 INDX PTFE tube paths to the backside mounted filament sensors for 4 Tool, 6 Tool, 8Tool configurations

Variants available:

  • 4 Tool high mount (left and right side storage accessible)

  • 6 Tool right mount (left side storage accessible)

  • 8 Tool left high and right mount (left side storage accessible) 

The PTFE path mounts are thought to lead 1-8 tubes to the filament sensors on the backside.

For easier filament feeding i use this filament guide

Non printable parts needed:

  • 1 M3x10 screw per mount

  • 1 M3nN nut needed only for the middle mount location

  • 1 PTFE tube pass-through connector M10x1 per Toolhead

Printing recommendation:

  • 0.4 nozzle

  • 0.2mm balanced

  • 3 perimeters

  • 3d-honeycomb or gyroid infill

  • supports on build plate only

Mounting instructions (see picture below):

  • Screw in the PTFE tube connectors from the backside into each mount, dont overtighten

  • high mount version: remove the screw on the top right or left backside, use a M3x10 screw to attach the mount

  • middle mount version: use a M3x10 screw and attach the mount on the second free hole from the bottom. Use the M3nN nut on the inside to fix the mount 

  • now connect every filament sensor, using a PTFE tube, with the corresponding PTFE connector on a mount. Let the tube go through the pass-through connector for 20mm

  • For easier filament feeding, use this filament guide on the hose protruding by 20 mm, then push the guide back until it stops at the connector

  • When using an USS Dry Box, feed the PTFE tube from the box through the corresponding hole on the mount to the filament sensor connection

A Filament mounting system to use the above solution.

An adapted filament path solution is also available.

Tagi