Berocca Holder, Effervescent Tablet Tube Organiser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds 8 effervescent vitamin tubes (Berocca and similar) in two rows of four. STL plus OpenSCAD source for any layout.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 25
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Somewhere to keep your Berocca tubes, sized to the tubes rather than to a guess. Two rows of four, and any other layout you like.
Files
STL: berocca_2x4.stl. Two rows of four, any slicer.
SCAD: Berocca-Holder.scad. The parametric source: open it in OpenSCAD (free) and set rows and columns in the Customizer panel for any other layout.
Which one do I print?
The STL holds 8 tubes in two rows of four: about 82 g of PLA and 1 h 54 min. For any other layout, open the .scad and set the rows and columns.
Why this design
Lid first. The spacing is worked out from the wider lid diameter, so tubes sit side by side without their lids touching, even packed tight.
Stable and secure. The holes are sized to the tube base for a wobble-free fit, with the clearance handled by the hole spacing.
Drain holes. A small hole under each tube, so crumbs and dust fall through instead of collecting.
Fully parametric. Set the rows, columns, depth, tube and lid diameters, wall thickness and the gap between lids.
Print settings
Material: PLA or PETG
Layers: 0.2 mm
Walls: 2 for the profile as supplied, 3 if it will be moved about full
Infill: 15%, gyroid or grid
Supports: None
Print it flat as supplied. If you find a layout that works well for your cupboard, I would love to see a photo in the comments.
The photos show other brands of effervescent tube; anything around 29 mm across with a 34 mm lid fits.
Not affiliated with or endorsed by Berocca. The name is used only to say what this fits.
The OpenSCAD was written with AI help; the sizing and testing are mine.
If it is useful, a like and a make with a photo really help. I read every comment.
Also on MakerWorld: https://makerworld.com/en/models/2505570