8 Port LED Distro MTM AC30C-11 mount

This is the stuff needed to mount the 8 Port LED Distro and a PSU into an MTM AC30C-11 case.

You can buy the 8 Port LED Distro in our Tindie store: https://www.tindie.com/stores/bong69/

The PSU mounts fit this 12V 30A power supply: https://www.amazon.com/dp/B06XJVYDDW

What to print

• 1 x AC30C-11_PSU_mount_back

• 1 x AC30C-11_PSU_mount_front

• 2 x 8_Port_LED_Distro_PSU_mount

• 1 x AC30C-11_hole_drill_guide

Screws for mounting to your power supply

• 4 x M3 x 6 mm hexagon socket button head screws (ISO 7380-1)

• 8 x M4 x 10 mm hexagon socket button head screws (ISO 7380-1)

Glands and connectors for the power, Ethernet and output cables

• 8 x PG7 glands

• 1 x PG9 gland

• 1 x RJ45 waterproof connector: https://www.amazon.com/dp/B08CDD2BRF

Drill bits

• 1/16" drill bit

• 1/2" Forstner bit for PG7

• 5/8" Forstner bit for PG9

• 3/4" Forstner bit for RJ45

OR a metric step bit with these sizes:

• 12 mm for PG7

• 15 mm for PG9

• 20 mm for RJ45

The 3/4" Forstner is a little small for the RJ45 waterproof connector. You can use a knife to make the hole a little bigger.

Drilling the case
Tape the hole drill guide to the back of the MTM AC30C-11, underneath the hinge. Use the 1/16" drill to mark the location of each hole, then use the larger bits to drill each hole to the correct size.

You can get pigtail cables here: https://www.wiredwatts.com/wire

More about the 8 Port LED Distro

• Product page: https://www.bong69.com/led-distro.html

• FAQ and setup guide: https://github.com/bobko69/8PortLEDDistro/blob/main/README.md

• Light shows and videos: https://www.youtube.com/@bobko69

Print settings

• Material: PETG

• 4 walls (perimeters)

• 4 top layers

• 4 bottom layers

• 25% infill