1 / 3
Uno Q to R Pi adapter for displays et. al. — zdjęcie 1
1 / 3

Uno Q to R Pi adapter for displays et. al.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter that permits mounting an Uno Q + media carrier onto a display preconfigured for a Raspberry Pi

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
15
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

The Arduino Uno Q is a newer Arduino board that combines an MCU and CPU in an Arduino Uno footprint. The board can be mounted on an accessory, the Uno Q media carrier board, which permits use (among other things) on small displays. At present, the WaveShare 10.1",  8", and 5" displays are supported by the UnoQ environment. See documentation on the Arduino and WaveShare websites and in the App Lab.

Practical use of the Q on these displays is a little tricky. The mounting holes on the display are designed to mate with a Raspberry Pi. The Media Carrier board connects to the Q's underside, and the Carrier Board has no mounting holes. One could make a mounting adapter that assumes that the Carrier board would be on top, but that configuration blocks easy pin access (the Arduino pins are available on the Carrier board, but a specialized connector would be required. Yuk.

An adapter that maintains easy access to the Arduino's pins keeps the Arduino on top. However, it would be awkward to use all four mounting holes because one of the holes is directly above the display cable connector. Even using the cantilevered approach I've taken, the display cable connector would be blocked.

After more trial and error that I care to admit to, this frame fits the bill. All Arduino pins are accessible, as are all Carrier Board connectors. Mounting holes are sized for 2.5mm screws; 6mm length was fine for mounting the frame to the display, and 8mm length screws were used to mount the Arduino/Carrier to the frame. Layout is optimized so that on both the 5" and 8" boards, the display cable doesn't need to bend through any tight angles.

Printed on an MK4S with PETG and 25% infill, 0.2mm layer height. Designed using SolidWorks maker edition. I've posted the .stl and the .sldprt files. If the .sldprt design is a little funky, gimme a break, I'm still learning.

Tagi