2018-2026 Jeep Wrangler/Gladiator Metal Door Storage Box Bumpers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Line the top of the metal door storage box so it's not uncomfortable on your leg.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I say this fits 2018-2026 JEEP Wranglers and Rubicons, because that's what the Amazon description says. I have a 2022 Wrangler and I designed this for the metal door storage box I bought to replace the ridiculous door nets. Here is a link to the one I bought. I get no compensation, just FYI.
The one I bought scratched my leg a lot. I could have tried to sand the edges, but that would have ruined the finish. So, I designed these parts to soften that edge. There are four parts to cover the entire length of the box. In reality, you only need to print part 1 to cover the front. That's where your leg will hit. The other three parts are really just for show. There are also little flanges at about 13.8 mm from the inside of the channel that catch on the top of the molle cutouts to secure them in place. They hit in the middle of cutouts in my box, and may also work on yours. If not, use flush cutters to cut them off.
I imagine that most of the metal storage boxes are about the same design, so these parts should fit. I attached the picture from the Amazon listing with dimensions so you can compare to whichever one you have to see if these would work. I also included a PDF that you can print to check the angles and measurements on your box to see if the parts will fit.
I have printed these with PLA and TPU (Flex) filament. Either will work.
I also included straight pieces (Part1Straight and Part2Straight) with wide notches to aid bending. If your measurements are a few mm off from mine, print these with TPU and they may work.
If you use these on another brand/design, PLEASE post a make with pictures and maybe even a link to the one you bought so others can see if it might fit theirs too. Thanks.