Sink Sponge & Brush Caddy with Drain – No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sink caddy for a sponge and dish brush with a sloped, ribbed floor and two drain spouts. No supports.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 41
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Standard Digital File License
A sink caddy for a kitchen sponge and a dish brush. Water does not sit in it: the floor slopes toward the front, ribs keep the sponge off the floor so it dries, and two spouts let the water run back into the sink.
Sponge bay 97 x 81 mm (fits standard 100 x 70 x 45 sponges), 11 drying ribs.
Brush cup 32 mm inside, 55 mm tall, with its own drain slot and spout.
Sloped floor 1.0 to 2.2 mm toward the front; place the spouts over the sink edge.
Low front wall (16 mm) so the sponge is easy to grab.
Prints flat on the bed, no supports.
Print settings
Orientation: as supplied. No supports.
0.20 mm layer, 2-3 walls, 15% infill. PETG recommended for a wet place, PLA works too.
Bambu Lab A1, PLA, 0.20 mm: 1 h 40 min / 60.7 g.
Designed from scratch by bezbajzlu.