1 / 9
Mini SVS Prime Bookshelf Speakers (3.5in woofers) — zdjęcie 1
1 / 9

Mini SVS Prime Bookshelf Speakers (3.5in woofers)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mini replicas of the SVS Prime Bookshelf Speakers

Ocena
0 / 5
Polubienia
3
Pobrania
23
Wydruki
0
Wyświetlenia
186
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution — Noncommercial

These are Mini replicas of the SVS prime Bookshelf speakers, I created them to pair with my mini SVS PB-17 Ultra V2 subwoofer and boy do they sound great! Very tight balanced sound, good bass and clean highs if you have a decent amp to power them. 

 (Link to my Mini SVS Pb-17 Ultra V2 if you want to print it as well: https://makerworld.com/en/models/3267720-mini-svs-pb-17-ultra-subwoofer-v2#profileId-3704967

Speakers: Peerless by Tymphany SLS-85S25CP04-04

AMP: DAJUNGUO S600X 2.1 Channel Amplifier Board 300W+300W+600W 

Power Supply: AIYIMA DC48V 10A GaN Power Supply (48v supply needed to get full power from the amp)

 

HARDWARE: 

(36) M3 x6mm cap head self tapping screws (Enough for two speaker boxes)

(2) 2.2 Inch Square banana plug speaker spring terminals

(24) 6x3mm round magnets (only needed if using the speaker grills)

(Optional) fiberfil (cotton, like you fill pillows with) to stuff the inside of the speaker box (it helps speaker boxes sound better with deeper bass)

 

PRINT SETTINGS:

Any hard filament for box, SVS bandge, tweeter and grill (I used Petg-cf for my box to give it a nice matte finish to hide layer lines)

 TPU for gaskets and speaker feet

 Printing the box slower than normal recommended since these are printed at a 45deg angle

 .2 Nossle necessary for printing the fake tweeter, it has very tiny grill details that won't print with a .4

 .2 Nossle recommended for svs badge (but yuo can probably get away with a .4 if need be)

 

Assembly:

On the box back you glue and insert the port tube into the port hole from the inside side of the box back, long part points down

Wire up your speaker

Put TPU gaskets on the box back, terminals and speaker before screwing them in with M3 x 6mm screws

Screw in the TPU speaker feet to the bottom of the box

 

For the speaker grill, to finish it like I show in the pictures you use 3m spray glue to attach stretchy speaker grill cloth (you can get it on amazon etc), then just use a razor knife to cut excess from the back side of the grill

 

If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ