Flattened SP Rear AGS-001
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
allows for the larger stock screen from AGS-001 to fit in the shell. May work on stock AGS-101 screen but untested
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 13
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Build as described in original model. You'll need to remove the spacer foam from the back of the screen. I also clipped the pins on the other side of the ports near charging and link ports, but out of caution more than necessity. Just make sure you check that the ribbon cable isn't going to get damaged during install. And lastly, fdm printed screw posts are fragile so be careful during the case install to only tighten the screws snug enough to close the gaps and then stop.