1 / 3
Key Lever Handle for Schlage-Style House Keys — zdjęcie 1
1 / 3

Key Lever Handle for Schlage-Style House Keys

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lever handle for a Schlage-style house key. Glue the key in for easy turning on a stiff or sticky lock.

Ocena
0 / 5
Polubienia
1
Pobrania
0
Wydruki
0
Wyświetlenia
11
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

A lever handle for a Schlage-style house key. The key's head is glued into a slot at the bottom of the handle, and the handle steps up and out to one side, so you turn the key with a lever about 82 mm long instead of pinching its head.

It's been helpful for letting our kids back in through a door with a sticky lock.

How it works

  • The key's head goes into a slot in the bottom of the handle. The blade sticks out below, and a small chamfer at the opening helps the key start.

  • Glue is needed to hold the key in place. Superglue works; epoxy is also a good choice, since it fills any gap around the key's head.

  • The hole at the end is for a lanyard.

Before you glue

Use a copy of your key, not your only one. Once it's glued in, it stays in.

Push your key into the slot dry first. Its head should go all the way in. If it's too wide or too thick, you'll need to alter the design.

Then glue it:

  • Put superglue or epoxy on the key's head, not the blade.

  • Push it all the way into the slot and wipe off any squeeze-out.

  • Let it cure fully before you turn the key in a lock.

Printing

  • PLA, 0.20 mm layers, 4 walls, 40% infill. That's more than Prusa's STRUCTURAL profile uses (2 walls, 15%), for the turning force.

  • Print it flat on its side, the way the STL is oriented. No supports, no brim.

  • 105 × 61 × 9.3 mm, so it fits a 180 mm bed.

  • G-code is included for the Prusa MINI/MINI+ (0.4 nozzle, Input Shaper firmware) and the CORE One L (0.4 HF nozzle), both in Generic PLA: about 43 and 39 minutes, about 17 g.

How AI Helped

This is my design. I designed the handle in Tinkercad. An AI assistant checked the model, suggested and made two small changes (the slot chamfer and moving the lanyard hole in for more plastic around it), and helped me draft the documentation.

Tagi