1 / 2
Pumpkin Sweets Bowl - Ribbed Halloween Candy Bowl, No Supports (OpenSCAD) — zdjęcie 1
1 / 2

Pumpkin Sweets Bowl - Ribbed Halloween Candy Bowl, No Supports (OpenSCAD)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A ribbed pumpkin bowl for Halloween sweets, 14 cm across. Change size, ribs and opening in OpenSCAD.

Ocena
0 / 5
Polubienia
3
Pobrania
35
Wydruki
0
Wyświetlenia
68
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A ribbed pumpkin bowl for trick-or-treat sweets, snacks at a Halloween party or as an autumn decoration on the table. Eight rounded lobes give it a proper pumpkin shape, and the top is cut open wide enough for a hand to reach in.

Every surface is printable without supports: the underside is cut where the lobes reach 45 degrees, so the bowl sits on a flat base and the rest of the shape builds up cleanly. The walls are 2 mm thick all round. Size: about 140 mm across and 51 mm tall.

Make it yours: open the .scad file in OpenSCAD (free), go to Window > Customizer, and change the diameter (80 to 220 mm), the number of lobes (5 to 14), the wall thickness and how far up the top is cut open.

Print settings: orange PLA, 0.2 mm layers, 3 walls, 15% infill, no supports. It is not food safe for unwrapped food, so use it for wrapped sweets or put a paper liner in. On a Bambu Lab H2C it takes about 1 h 53 min and 74 g. A ready plate (the H2C .3mf) is included.

Designed with AI assistance, checked and sliced by me. License: CC BY-NC-SA 4.0.

Tagi