1 / 1
4" Tote Duct Collar – Short (Flanged Bulkhead) — zdjęcie 1

4" Tote Duct Collar – Short (Flanged Bulkhead)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a flange I created for routing to 4 inch tubing

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
11
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

A simple flanged collar that turns any plastic storage tote into a ducted enclosure. Cut a 4" hole in the tote wall or lid and push the collar through until the flange seats. Then clamp standard 4" flex duct or an inline fan onto the tube.

This is the short version, with about 50 mm of tube on each side of the flange. That’s enough for a hose clamp or zip tie on the outside, and it doesn’t stick far into the tote.

Dimensions

  • Tube OD: 101.6 mm (4.00") to fit standard 4" flex duct and fan collars

  • Tube ID: 95.6 mm

  • Wall: 3.0 mm

  • Overall height: 103 mm

  • Flange OD: 131.6 mm, 3 mm thick, centered, with 45° fillets at the root for strength

Installation

  1. Mark and cut a hole with a 4" (102 mm) hole saw or step bit. A snug fit is best, so test on scrap tote plastic first.

  2. Push the collar through until the flange sits flat against the tote wall.

  3. Seal the flange with silicone, foam tape or hot glue for an airtight joint.

  4. Clamp the duct over the outside of the tube with a hose clamp or zip tie.

Print settings

  • Orientation: upright (tube axis vertical)

  • Supports: yes, for the underside of the flange only (tree supports or support blockers work well)

  • Layer height: 0.2 mm

  • Walls: 3–4 perimeters (the 3 mm wall comes out close to solid)

  • Infill: 15–20% (this only affects the flange)

  • Material: PETG or ASA for humid, warm or outdoor use; PLA is fine for dry indoor use

  • Filament: about 145 g

Notes

  • Designed in OpenSCAD.

  • Real duct sizes vary. Some 4" flex duct is snug on a 101.6 mm OD and some is loose, so check yours.