Dish Towel Holder for Cabinet Door - Screw-On Loop, No Supports (3 sizes)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screw-on loop for a dish towel inside a kitchen cabinet door. 3 window sizes, prints standing, no supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 5
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Standard Digital File License
A solid loop that screws to the inside of a kitchen cabinet door. Pull the dish towel through the window, fold it back, and it hangs there: no hooks, no clips, nothing to fall off, and it lets go with one tug. Great under the sink or next to the oven.
Three window sizes: S 50 mm, M 62 mm, L 80 mm tall (all 23.5 mm deep and 22 mm wide). M takes a normal tea towel folded in half or thirds, L takes thick bath/hand towels.
Strong where it matters: the whole part is one profile extruded 22 mm wide, so every layer line runs around the loop and the pull stays in the plane of the layers. Rounded inner corners are gentle on fabric.
Easy to mount: two 5 mm holes with 90° countersinks in the plate ends, above and below the loop, so you reach them with a screwdriver from the front. Use 3.5-4 x 12-14 mm wood screws (16-18 mm doors) or strong double-sided tape.
Prints standing up with no supports: the profile stands on its edge, every wall is vertical.
Print settings
Orientation: as supplied (profile standing on the 22 mm edge). No supports, no brim needed.
0.20 mm layer, 3 walls, 15% infill. PLA or PETG.
Bambu Lab A1, PLA, 0.20 mm: S - 39 min / 15.1 g; M - 41 min / 17.2 g; L - 45 min / 19.8 g.
Designed from scratch by bezbajzlu.