1 / 7
Latched Storage Box: your size, trays and logo — zdjęcie 1
1 / 7

Latched Storage Box: your size, trays and logo

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Hinged box with latches and removable trays. Pick a preset or set size, trays, logo and QR in a browser editor.

Ocena
0 / 5
Polubienia
4
Pobrania
10
Wydruki
1
Wyświetlenia
46
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

A storage box with a hinge at the back, latches at the front and removable trays inside. The box, the lid, the hinge bar, the latches and the trays are separate parts and print without supports.

Make it yours

Every size, tray layout, wall pattern and image is a setting in a browser editor: https://fullmesh.ai/constructor/demo/f-tGc1ab/latched_box/?ref=printables

  • Inside width 80-225 mm, inside length 150-220 mm, depth 40 or 80 mm, 1, 2 or 4 latches.

  • Split the box into trays by drawing lines; each tray shows its size.

  • Tray wall pattern: Flat, Waves, Ribs, Twist or Bubbles.

  • Your own logo on the lid (SVG or PNG with a clean background, up to 4 colors) and a QR code to your link on the bottom.

  • The editor gives you a 3MF with all parts laid out, or STL files.

Four ready presets in the files

  • Gift box: 2 trays, 170 x 225 x 44 mm outside

  • Desk organizer: 6 trays, 170 x 225 x 44 mm outside

  • Tabletop game box: 8 trays, 222 x 241 x 84 mm outside, 4 latches

  • Bead & craft storage: 12 trays, 170 x 225 x 44 mm outside

Printing

  • PLA, 0.4 mm nozzle, 0.2 mm layers, no supports.

  • Parts are laid out over several plates when the box does not fit on one. The Gift box takes about 11 hours and 340 g of PLA on a Bambu A1.

  • The logo and the QR code are painted on the outer faces, so a printer with several filaments (AMS) prints them in one go; with one filament the box prints in a single color.

  • Light filament for the box and dark for the QR code scan best. Keep the QR code at least 25 mm wide and test it with your phone before printing a batch.

  • Open the 3MF in Bambu Studio or OrcaSlicer, pick your own printer and keep the per-object settings when asked. The STL archive holds the Gift box parts.

Assembly

  1. Put the hinge bar through the back of the box and lid.

  2. Clip the latches on at the front.

  3. Drop in the trays. They are thin-walled (0.8 mm) and fit with a small clearance; if they are too tight, raise "Fit clearance" in the advanced settings of the editor.

If you print it, please post a Make with a photo and tell me what did not work. If you build your own design in the editor, paste the link in a comment.

Tagi