Drive-side axle spacer for Orbea Wild FS

Replaces the plastic spacer that holds Orbea's X160 derailleur hanger in place and allows you to clamp the rear triangle.

This spacer is a part of the Orbea X203 hardware kit, which is available for around 25 euros.
Are you better of buying the original part? Probably.
Do you want to wait 6 weeks without being able to ride the bike?
I guess not, so use this part "temporarily" and replace it with the OEM part "eventually" ;-)

Print the part entirely out of perimeters (no infill).
No supports are needed.

If the part doesn't fit by a smidge, your printer likely doesn't have tight enough tolerances, so just add some clearance to the inner or outer diameter, but note it should fit tightly, as we're only dealing with 1mm overlap between the axle head and the spacer to provide all the clamping force for the rear triangle - might actually be wise to find a spacer to go underneath the axle head to address this issue, but it isn't strictly necessary if the parts fit tight and this is actually a temporary installation.

And where did the metal bearing spacer for the "cap" version came from?
Well, I have no idea, it was installed underneath the OEM plastic spacer when I bought the bike, despite it appearing nowhere in the Orbea's exploded diagram, so go figure...
Since I don't suppose it normally comes with the bike, I've also included a standalone version that doesn't need it.