SOLDR 20ml Bottle holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnet base for a generic little 20ml bottle that can be filled with flux or alcohol.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 19
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The main cylinder of the bottle is 25x53mm, the whole bottle height is 90mm. The plastic parts of holder are squished between bottle base and cap. The metal nozzle should be trimmed in half and a little bit of material should be removed from the top of rubber cork for perfect fit. Be careful to not overdo them so it still will be possible to seal it properly. Also its a good idea to place some material in thread between bottle and cap to prevent leaks. It is redesign of original flux syringe holder, but top magnet was removed because it was pulled to the soldered parts while placing the contents of flasks.
The specific adjustments for print are:
- The part should be printed with bottle side placed on the bed (No supports)
- 5 Walls
- 7 Bottom shell layers
- "Arachne" wall generator