Nerf Jolt Inspired By Glock 19 Body

This mini Glock 19 body designed for the Nerf Jolt turns the silly little blaster into an intimidating mini Glock (especially if your Jolt is modified).

You will need to do a few things before you can install this:

First: if your Jolt has a plastic cover on the end of the barrel (below), then you need to remove that.

This mini Glock 19 body designed for the Nerf Jolt turns the silly little blaster into an intimidating mini Glock (especially if your Jolt is modified).

Printing:

I used 0.3mm layer height with 15% infill, but it is flexible for what you want to print with.

You will need to use supports, but only for the internal overhangs (I used paint-on supports in Prusaslicer).

Post-Processing:

You will need to do a few things before you can install this:

First: if your Jolt has a plastic cover on the end of the barrel (below left), then you need to remove that, unless you have a model with no cover (below right).

Second, after you remove the cover, you need to shave (or sand or cut) the small ring on the end of the barrel (circled in red below) so that the main body piece can slide right onto the blaster.

Assembly:

1. Slide the main body piece (Nerf Jolt 19 Body.stl) backwards on the blaster, starting from the front of the barrel, until it stops.

2. Glue the rear panel piece (Nerf Jolt 19 Panel.stl) to the back of the body piece. There is a small rectangular slot that the rear panel matches up with for ease of assembly.

3. If you printed the muzzle break, then just glue it to the front of the body piece.

Let me know if there is any improvements that need to be made.