1 / 2
Prusa i3 MK2 Filament Filter with 4mm PTFE tube — zdjęcie 1
1 / 2

Prusa i3 MK2 Filament Filter with 4mm PTFE tube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I got this design idea while using cocoknight's snap-on filament filter ( http://www.thingiverse.com/thing:2086804 ).…

Ocena
0 / 5
Polubienia
1
Pobrania
21
Wydruki
0
Wyświetlenia
259
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

I got this design idea while using cocoknight's snap-on filament filter ( http://www.thingiverse.com/thing:2086804 ). It's well designed but I've different usage requirement.

I need a filament filter that able to:

  1. Snap-on top of Prusa i3 MK2 extruder, but easily remove-able.
  2. Able to put an 4mm PTFE tube into it.

So this is what design I came out with.

I use idler as snap-on point. It seat secured enough as filament movement will push it downward naturally. And it's easily remove-able, all you need to do is lift it upward, which make unloading filament very easy (won't jammed with filter).

On top you can insert 4mm PTFE tube into it. PTFE hole is (designed to) 4.24mm in diameter with 4mm depth. Then there is a smaller 3mm diameter hole below it act as stopper to prevent over-insert.

In order to make it print-friendly, I put a 0.2mm single layer at the bottom of filament entry hole. You need to remove this single layer after print.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Mk2

Rafts:

Doesn't Matter

Supports:

No

Post-Printing

There is a 0.2mm single layer print at the bottom of filament entry hole in order to make it print-friendly. You need to remove this single layer after print.

Category: 3D Printer Accessories

Tagi